Changing Anton with replacement casing

Step by step guide: 

Make sure you have received all the parts: 

• Anton plastic casing 
• Anton plastic wall mount 
• 4 plastic pieces/bars to mount tablet and payment terminal in the casing
• 8 screws and 4 washers

1. Take down the old Anton and wall mount 

1. Use the key to unlock the Anton from the wall mount.
2. Lift up the Anton to take it off the wall mount - detach power to move it further.
3. Take out the 2-4 screws holding the wall mount, and take the wall mount down 

2. Install the new wall mount 

1. Find the 4 washers provided in the plastic casing kit. Use the screws from the old mounting along with the washers to install the new wall mount. It is designed so that the new wall mount should fit with the holes from the previous mount. 
2. Make sure to use the washers on the plastic wall mount to increase strength. Make sure to install the mount with the correct side up. The side with the arrow should be facing towards you when hung on the wall - so the flat side of the mount is against the wall. 

3. Take out parts that needs to be transferred to the new casing 

1. Place the Anton on a table and look at the backside 
2. Remove the key lock - Use an adjustable wrench to loosen the key lock and dismount it. 
3. Remove the tablet from the metal casing - Use a tork screwdriver to remove the screws securing the tablet 
4. Remove the payment terminal from the metal casing 
5. Use a tork screwdriver to remove the screws securing the payment terminal ii. The entire payment part is taken out, along with the plastic, so that you have a part that fits into the plastic casing. 

4. Remove protection screen from the tablet 

If the tablet does not fit into the plastic casing with the protective screen, it has to be taken off. 

5. Install the parts in the new casing 

1. The two short plastic bars are used along with the four long screws to attach the payment terminal. Place the payment terminal in the correct position and then lock it with the plastic bars. 
2. The two long plastic bars are used along with the four short screws to attach the tablet. The one with the rounded corners is placed at the top. Mount the two bars in the casing with the short screws, and then afterwards slide the tablet into position. 
3. Install the key lock on the Plastic casing. 
4. Replug the power to both the tablet and the Stripe terminal. 

6. Sticker transfer 

Inside or on the bottom part of the metal casing, there is placed a sticker with serial number and information about the tablet - this should be transferred to the new plastic casing as well. 

7. Mount the Anton on the wall 

Mount the Plastic Anton on the wall, by sliding it down from the top onto the wall mount. When mounted correctly you will be able to lock it in place, with the lock mechanism on the side.

Updated on: 11/02/2026